Power UNITS FOR LIFT TABLE

Energy UNITS FOR LIFT TABLE one
Basic Description
This energy unit is created solely to the tiny lift table,Consisting of large strain gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This energy unit continues to be widely utilised during the business of logistic units such as minifork lift, scissors lift and ariel operating platforms. The lower-ing movement is controlled through the solenoid valve with all the pace controlled through the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
Basic Description
This power unit is designed exclusively for your medium lift table, Consisting of very effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve and also the pace controlled through the adjustable needle valve. When the lift rises to a large positoin, however the power supply is cut, the reducing motion is managed through the guide override perform.
Energy UNITS FOR LIFT TABLE three
General Description
This energy unit is created solely for that significant lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived by the solenoid valve and the pace managed by a pressure compensated movement handle valve.
Power UNITS FOR LIFT TABLE 4
Basic Description
This electrical power unit is made exclusively for that big lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve along with the pace controlled from the adjustable needle valve. Once the lift rises to a large positoin, but the power supply is reduce, the decreasing movement is controlled by the manual override perform.
Distinctive Notes
1. This power unit is of S3 duty cycle, which may only get the job done intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean all of the hydraulic parts concerned prior to installation of the energy unit.
3. Viscosity of your oil shoud be 15~46 cst,which should also be clean and free of impurities.N46 hydraulic oil is recommended.
4. Oil shifting is needed just after the preliminary a hundred operation hrs,afterwards once every 3000 hours.
five. The energy unit proven is intended to be mounted vertically.

Tags:

Recent Posts

Tyre Coupling

As one of Tyre Coupling manufacturers, suppliers and exporters of mechanical products, We offer tyre-coupling and many other products.

Please contact us for details.

Mail:[email protected]

Manufacturer supplier exporter of tyre-coupling.