1.A connecting hyperlink of an O-ring Chain for standard application is pre-coated with grease in the pins. Ahead of connection, confirm the grease over the surfaces of pins, and when the quantity of grease is little, apply grease with bare hands. (If gloves are used, the grease will be absorbed from the gloves.)
Example: Once the connecting hyperlink (I) of an O-ring chain for basic application is
shipped, O-rings are fitted with the roots with the pins. Should the O-rings come loose because of vibration throughout transport, refit the O-rings in on the roots with the pins.
In this instance, make sure you return the grease collected with the roots on the pins to your central surfaces in the pins, far more at portion A than at portions B proven in the over illustration. (Portions A is worn as a result of sliding using the bushings.)
2.The chain could be most very easily connected on the teeth of a sprocket. Engage the back links at both ends of the chain using the sprocket teeth and fit connecting pins. In the event the sprocket may be moved, the chain may also be connected over the loosened side.
three. Connecting process
1.Verify that O-rings are connected towards the roots on the pins.
two.In the event the quantity of grease applied over the connecting pins is modest, coat the pins with grease with the central portions.
3.Insert the connecting pins in to the bushings of the inner hyperlinks at both ends.
4.Verify the grease is applied towards the complete encounter of the O-ring, and fit the O-ring onto the connecting pins.
five.Insert the connecting pins into the connecting plate and while pressing the connecting plate, install the spring clip. Confirm no matter whether the head (the finish without a split) from the spring clip is turned inside the feeding path of your chain. (See the following illustration.)
six.You should definitely confirm that the spring clip is securely fitted during the clip grooves on the connecting pins.
This completes jointing with the connecting website link. Note that grease to the surfaces of connecting pins and O-rings is often eliminated in the course of set up work. In this case, re-grease making use of the grease about the surface with the base chain or even the grease while in the polyethylene bag in which the connecting hyperlink was contained.